Ceiling Air Filtration System with Negative Pressure Function
페이지 정보
조회 219회 작성일 23-03-29 10:21
본문
Ceiling Negative Pressure Unit
INTRODUCTION
Ceiling Negative Pressure Unit can be installed on the ceiling of the patient rooms to convert it into a temporary
Negative Pressure Isolation Room(NPIR) in case of an emergency case related to infectious diseases.
After the use of NPIR is done, our ceiling negative pressure units can be used for ventilation and air purification(optional).
It takes much less time and cost then constructing a typical NPIR.
Installed device
Controller
CHARACTERISTICS
COVER RANGE
Ceiling Negative Pressure Unit applicable for up to 100㎥ ±15% room
GENERAL FEATURES
Aerodynamic design presents significantly less noise and vibration compared to other similar products
PRE filter grabs large particle dusts
HEPA filter grabs fine dust and high-risk pathogens
Digital display installed outside the room to check the negative pressure status inside the room.
Air volume adjustable by BLDC motor (0 ~ 25 CMM)
NETWORK SYSTEM (Optional)
Built-in RS485 network system allows you to check and control the negative pressure status
and filter replacement cycle of the rooms at the central management room
SPECIFICATION